Busbar processing machine cleaning method

Any machine that has been used for a long time will generate a lot of dust and product debris. If it is not cleaned up in time, it may cause the machine to operate normally. Therefore, for the bus processing machine, in addition to the maintenance work, the cleaning work is also the key. Here's a look at the cleaning method:
First, hot oil cleaning method
Because the bearing used for a long time, hardened oil or rust-proof paste should be immersed in the hot oil of 100-200 °C, clamp the bearing with pliers, and clean the oil on the bearing with a brush. The soft dry oil or anti-rust paste is melted when heated to 100-200 ° C, and is easily washed out from the gap of the bearing. Sometimes the bearing is shaken repeatedly in the oil. Oil stains will also flow away from the gap. When cleaning the old spherical machine motor or the radial spherical bearing of the imported motor, the ball, the bead frame and the inner ring should be laterally turned out from the outer ring and then immersed in the hot oil. When the short cylindrical roller bearing is cleaned, the roller, the bead frame, the inner ring and the outer ring should also be disengaged. When the hot oil is cleaned, the temperature of the oil should not exceed 20 °C. If you use an open flame to directly heat, you should pay attention to avoid burning the oil. The bearing should be hung in the oil pan, and the bottom will cause overheating and reduce the hardness.
Second, the general cleaning method
Soak the bearing in the oil for 5-10 minutes, pinch the inner ring with one hand, and change the outer ring with the other hand. The dry oil or anti-rust cream on the bearing will fall off. Then put the busbar processing machine bearing into the cleaner oil, rinse it with a soft and soft brush, wash the oil in the ball and the gap, then put it in the gasoline for 1 time, take it out and put it on clean paper. . When the radial spherical ball bearing and the short cylindrical roller bearing are cleaned, the ball, the bead frame, the inner ring and the outer ring should be disconnected and cleaned, and the bearing mounted on the shaft of the bus processing machine should be cleaned mainly by oiling or spraying with a grease gun. The method is to clean the oil directly and use the oil first. After using the oil, it is difficult to clean the oil. First, use 100-200 °C hot oil to rinse or oil spray, then clean with gasoline. Be sure to pay attention not to scratch the bearing with sharp objects: hard grease or rust, to avoid damage to the bearing tumbling and groove ring finish, clean the bearing with a clean cloth to dry.
Therefore, Xiaobian reminds everyone that when using the bus processing machine in the future, it is necessary to do his cleaning work from time to time.